3 hp 182T electric motor 1800 rpm 3 phase PE182T-3-4-ODP

• Meets or exceeds NEMA Premium® Efficiency Requirements defined by NEMA MG-1, Table 12-12
• Rolled Steel Frame on 215T frame and below
• Corrosion resistant paint
• Suitable for wye-delta start on 213T frame and above
• 40° C ambient continuous duty
• Dual voltage ratings 254T and above are suitable for part wind start on lower voltage
• Stainless steel nameplate and zinc plated hardware
• F1/F2 reversible from 254T – 365T and 444T – 449T
• 1.25 Service Factor @ 60 hertz; 1.0 Service Factor @ 50 hertz
• Feet are dual drilled on most frames for mounting flexibility
• Suitable for 575V @ 1.1 Service Factor
• Inverter Duty (20:1 variable torque; 10:1 constant torque)
• Cast iron frame construction on 254T frame and above
• Vacuum Pressure Impregnation for all windings
• Lifting provisions on 182T frame and above
• Sealed bearings thru 215T frame
• IP23 Protection
• Greasable bearings with slinger on 254T frame and above
• CSA + C + US Certification
• Class F insulation system, class B rise at full load
• ISO 9001 Certification

Notes

1. NEMA Premium® (NEMA MG-1 Table 12-12)
2. Inverter Duty (20:1 Variable Torque; 10:1 Constant Torque)
3. 12 Lead Partwind Start at 230V
4. 12 Lead Partwind Start at 460V
5. Ball Bearing on Drive End
6. Insulated Bearing on Opposite Drive End
7. Equipped with terminal blocks as standard
8. Inverter Rated (10:1 Variable Torque; 5:1 Constant Torque)